Setup guide

2-10 CP2210 Setup Guide
020-100524-04 Rev. 1 (05-2014)
Installation and Setup
• Always wear Christie approved protective safety clothing (P/N: 59-8900-095) whenever the
internal lamp door is open or while handling the lamp.
• Never attempt to access the lamp while the lamp is ON. Wait at least 15 minutes after the
lamp turns OFF before powering down, disconnecting from AC and opening the internal
lamp door.
1) Auto LampLOC
™
must be run any time the lamp is removed (inspected or
changed). 2) DO NOT place heavy objects on the open rear access door.
1. If the cinema projector is operating, turn it off and allow it to cool a minimum of 10 minutes.
2. Turn the breaker switch for the cinema projector off.
3. Disconnect the cinema projector from AC power.
4. Put on your protective clothing and face shield.
5. Use the security key to open the lamp door on the rear of the cinema projector.
6. Turn the two thumbscrews on the internal lamp door counterclockwise.
7. Install the lamp. See 6.8 Replace the Lamp, on page 6-4.
2.13 Connect the Cinema Projector to AC Power
• DO NOT attempt operation if the AC supply and cord are
not within the specified voltage and power range. See
Section 6 - Specifications from the CP2210 User Manual
(020-100410-xx).
• Always turn the cinema projector off before unplugging
the AC power cord. The appropriate ratings for the cin-
ema projector are listed on the license label on the back
of the cinema projector. Wait 15 minutes for the main
exhaust fan to turn OFF and for the lamp to cool suffi-
ciently before unplugging the cinema projector.
• Ground (earth) connection is necessary for safety. Never
compromise safety by returning the current through the
ground. Connect ground FIRST to reduce shock hazard
from high leakage.
NOTICE! Use the power cord provided with the cinema projector. DO NOT compromise
safety by using other connectors. For all other regions, ensure a power cord, power plug, and
socket that meet the appropriate rating standards are used.
Table 2.1 Lamp Types Available for CP2210
Lamp Type
1.4kW CXL-14M
1.8kW CDXL-18SD
2.0kW CDXL-20SD
WARNING
Figure 2-8
AC Receptacle