Setup guide

Installation and Setup
CP2210 Setup Guide 2-11
020-100524-04 Rev. 1 (05-2014)
1. Connect one end of the cinema
projector power cord to the AC
receptacle on the rear of the
cinema projector and the other
end to an AC outlet.
2. Turn the AC switch to the left
(Figure 2-9).
2.14 Connect Sources and
Turn the Cinema Projector On
After you install the lamp, you can
connect external cinema servers and
sources. Before you ignite the lamp
for the first time, use this procedure
to ensure successful communication
with input devices.
1. Assign the cinema projector a unique IP address and enter a baud rate:
•Tap Menu > Administrator Setup > Communications Configuration.
• Enter the IP address for the cinema projector in the IP Address field.
• Select a baud rate for the input device in the Serial Speed (Baud) list.
2. Enter lamp information:
•Tap Menu > Advanced Setup > Lamp History.
•Tap Add Lamp.
• Complete the fields in the Add Lamp dialog.
•Tap Save.
3. On the Touch Panel Controller (TPC), tap and hold the green power icon
4. Complete a LampLOC™ alignment on the new lamp:
•Tap Menu > Advanced Setup > LampLOC™
Setup.
•Tap Do Auto.
5. On the TPC, tap and hold the light bulb icon to ignite the lamp.
6. Complete an optical alignment to optimize images displayed on screen. See Section 4.3 Basic Image
Alignment.
7. Adjust optical components if required.
Figure 2-9 Connecting to Power