Setup guide

3-4 CP2210 Setup Guide
020-100524-04 Rev. 1 (05-2014)
Connect Devices to the cinema projector
As shown in the tables, each available pairing of pins (±) is defined as either an input or output. Four inputs
and three outputs have already been predefined. Configure a pin as an input if you want the cinema projector to
respond to an incoming signal, or as an output if you want an external device to respond to the cinema
projector.
This diagram illustrates how to wire your own GPIO cable to a server or 3D device such as an infrared emitter.
Inputs Positive Negative Description
GPIN #1 Pin 1 Pin 20 3-D L/R Input Reference
GPIN #2 Pin 2 Pin 21 3-D L/R Display Reference
GPIN #3 Pin 3 Pin 22 Reserved
GPIN #4 Pin 4 Pin 23 Reserved
GPIN #5 Pin 5 Pin 24 Input
GPIN #6 Pin 6 Pin 25 Input
GPIN #7 Pin 7 Pin 26 Input
GPIN #8 Pin 8 Pin 27 Input
Outputs Positive Negative Description
GPOUT #1 Pin 9 Pin 28 External 3-D L/R Output Reference
GPOUT #2 Pin 10 Pin 29 Reserved
GPOUT #3 Pin 11 Pin 30 Reserved
GPOUT #4 Pin 12 Pin 31 Output
GPOUT #5 Pin 13 Pin 32 Output
GPOUT #6 Pin 14 Pin 33 Output
GPOUT #7 Pin 15 Pin 34 Output
PROJ_GOOD Pin 16 Pin 35 cinema projector Good
Figure 3-4 GPIO Circuit Diagram
GPO
GPO
To Center
Pin of BNC
To Shielding
of BNC
+5 VDC
(External Supply)
1K
2K
IR Emitter
Recommended Operating Point
Max. Current
Forward Voltage Drop
= 5 mA
= 50 mA
~ 1.1 V (@ 5 mA)