Setup guide

Connect Devices to the cinema projector
CP2210 Setup Guide 3-5
020-100524-04 Rev. 1 (05-2014)
3.5 Connect Devices to the 3D Connector
The 3D connector is a 15-pin D-sub connector (female) located on the PIB input panel. This table lists the
control functions available through the 3D connector.
PIN SIGNAL NAME DIRECTION DESCRIPTION
1 +12V Out Power to 3D device. Maximum 1A (total between both
+12V pins).
2 GND / Ground
3 GND / Ground
4 RS232_RX In Data to cinema projector from 3D device. 1200 Baud, 8
bits, no parity. Currently unsupported.
5 RS232_TX Out Data to cinema projector from 3D device. 1200 Baud, 8
bits, no parity. Currently unsupported.
6 CONN_3D_MODE+ Out SYNC from cinema projector. To cinema projector
GPO collector. Compatible with current cinema projec-
tor GPIO requirements and restrictions. (24VDC max,
50mA max)
3D ON = Hi logic level = O/P transistor ON
3D OFF = Low logic level = O/P transistor OFF
7 CONN_SYNC+ Out SYNC from cinema projector. To cinema projector
GPO collector. Compatible with current cinema projec-
tor GPIO requirements and restrictions. (24VDC max,
50mA max)
8 3D_INPUT_REFRERENCE+ In 3D L/R Input Reference (P)
(Voltage Limit: 1.4VDC to 12VDC)
9 +12V Out Power to 3D system. Maximum 1A (Total between both
+12V pins)
10 3D_INPUT_REFRERENCE- In 3D L/R Input Reference (N)
(Voltage limit: 1.4VDC to 12VDC)
11 3D_DISPLAY_REFERENCE+ In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
12 3D_DISPLAY_REFERENCE- In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
13 CONN_3D_MODE- Out 3D mode state from cinema projector. From cinema
projector GPO emitter. Compatible with current cinema
projector GPIO requirements and restrictions. (24VDC
max, 50mA max)
14 CONN_SYNC- Out SYNC from cinema projector. From cinema projector
GPO emitter. Compatible with current cinema projector
GPIO requirements and restrictions. (24DC max, 50mA
max)
15 Not connected