Setup guide

CP2210 Setup Guide 5-1
020-100524-04 Rev. 1 (05-2014)
5 Operation
This section describes how to operate the CP2210 cinema projector.
5.1 Turn the Cinema Projector On
DO NOT attempt to turn the cinema projector on if the AC supply is not
within the specified voltage range.
1. Ensure the circuit breaker for the cinema projector is ON.
2. On the Touch Panel Controller (TPC), tap and hold the green power icon.
3. On the TPC, tap and hold the light bulb icon to ignite the lamp.
5.2 Turn the Cinema Projector Off
1. On the Touch Panel Controller (TPC), tap and hold the light bulb icon to turn the lamp off.
2. On the TPC, tap and hold the red power icon. The cinema projector enters a cool down mode and
the fans and electronics stay on for 10 minutes. After this cool down period, the cinema projector enters
standby mode.
3. If you are servicing the cinema projector, or removing the protective cover, disconnect AC and turn the
breaker OFF.
5.3 The Touch Panel Controller (TPC)
The TPC is a touch-sensitive screen that you use to control the cinema projector. You can use the TPC to turn
the cinema projector and lamp on or off, select channels, and view status information. The TPC is mounted on
the rear of the cinema projector. You can tilt and turn the TPC to improve the viewing angle. There are two
USB ports under a cover on the rear of the TPC that you can use to download log files and install software
upgrades. You can disconnect the TPC from the cinema projector and an optional cable allows you to control
the cinema projector from a maximum distance of 100 feet.
If the TPC fails or is disconnected, press the emergency start button that is recessed on the faceplate. This starts
the cinema projector, turns the lamp on, and opens the douser.