Setup guide

Maintenance
CP2210 Setup Guide 6-3
020-100524-04 Rev. 1 (05-2014)
6.5.2 Clean the Lamp Reflector
Inspect the mirror surface (reflector) for cleanliness when you remove the lamp for replacement. Wear
protective clothing while inspecting or cleaning. Color variations on the reflector are normal.
Remove Dust
1. Brush most of the dust off with a camelhair brush or use a dust-free blower.
2. If some dust remains, leave it. Some dust is inevitable. Avoid unnecessary cleaning.
Remove Fingerprints, Smudges, or Oil
1. Brush most of the dust off with a camelhair brush or use a dust-free blower.
2. Fold a microfiber cloth and wipe the remaining dust particles off the lens with the smooth portion of the
cloth that has no folds or creases. Do not apply pressure with your fingers. Instead, use the tension in the
folded cloth to remove the dust.
6.6 Clean the Radiator Filter
Inspect the filter routinely and follow this procedure to clean it when it appears dirty.
1. Remove the top lid:
a. Loosen the 7 captive screws securing the top lid to the
cinema projector housing
.
b. Unlock the rear access door using the low security
key.
c. Lift the lid up from the rear of the cinema projector
and pull it away from the 2 tabs on the front skin.
2. Remove side skin service door:
a. Remove the 2 screws from the inside of the door.
b. To remove the door disengage the skin from the 2 snap
tabs.
3. Remove the radiator filter:
a. Loosen the thumbscrew securing the radiator filter door.
b. Pull the filter up and out.
c. Wash the radiator filter with water and a mild detergent or clean it with compressed air.
d. Ensure the air filter is completely dry and insert it with the air flow indicator facing toward the cinema
projector.
4. Reinstall the service door and the top lid.
Figure 6-1 Remove Radiator Filter