Setup guide

Troubleshooting
CP2210 Setup Guide 7-5
020-100524-04 Rev. 1 (05-2014)
7.19 The Display is Unstable
• Verify that the input device is connected properly. If the input device is not connected properly, the cinema
projector repeatedly attempts to display an image.
• The horizontal or vertical scan frequency of the input signal may be out of range for the cinema projector.
• The sync signal may be inadequate. Correct the source problem.
7.20 The Display is Faint
• Verify the input source is terminated only once.
• If the input is not a video source, use a different sync tip clamp location.
7.21 Portions of the Display are Cut OFF or Warped to the Opposite Edge
If you have resized the image, adjust the resizing settings until the entire image is visible and centered.
7.22 Display Appears Compressed (Vertically Stretched)
• Adjust the frequency of the pixel sampling clock for the input source.
• Verify the size and position settings are correct for the input source.
• Use an anamorphic lens for HDTV and anamorphic DVD input sources that have been re-sized and verti-
cally stretched.
7.23 Inconsistent Picture Quality
• Verify the quality of the signal from the input source.
• Verify the H and V frequencies of the input source are correct.