Installation Instructions
FCC ID: 2AO23-AWSP6 Model:AWSP6
• True Wireless Stereo (TWS) Bluetooth Speaker
• Micro USB Charging Cable (note: charging cable does not transfer data)
• Stand
included
• Power ON speaker
• When pairing for the rst time the speaker will automatically enter pairing mode
• Use bluetooth settings on your phone to pair with HEYDAY SPEAKER 07
• When the bluetooth is connected successfully you will hear a chime
pairing
• Plug micro end of charging cable into speaker
• Using the USB cable provided, plug into a USB power supply of at least DC 5V 1A
warning: please use UL compliant power supply
charging
• Answer/End Incoming Calls - Press the play/pause button
• Reject Incoming Call - Hold the play/pause button
phone calls
• To install the speakear stand insert the narrow part of the stand into the stand
slot, be sure not to press too hard so you do not damage the stand
• Make sure the stand is securely in place and not loose before setting up the speaker
installing the stand
• Insert 3.5mm audio cable (not included) into speaker AUX port
• Insert opposite end of audio cable into the music source
• Switch back and forth between Bluetooth and AUX by pressing the bluetooth button
while the aux cable is connected
aux/line in
You can pair two of this model of speaker together to get true stereo sound
•Turn bluetooth o on your device, place two matching speakers together, power them on
• Press the bluetooth button twice on one speaker - they will pair automatically
• Turn bluetooth on, on your device, and pair to one of the speakers
• When no music is being played the indicator will ash white on the speaker that is the
left channel and will be solid white on the speaker that is the right channel
• To maintain TWS pairing turn bluetooth o on your device before powering the speakers
back on, the speakers will pair automatically, then repair with your device
TWS (True Wireless Stereo) pairing
• If the speaker is not working correctly, turn it on/o to reset
• If the speaker won’t turn on, recharge the battery and try again
• If the speaker won’t charge, make sure the power supply works, is 5V 1A, and is not damaged
• If the speaker makes no sound or does not show as an available device, make sure it is
not paired, if so unpair and repair to the desired device
• You can reset the speaker to factory settings by holding the power button for 8 seconds
• This speaker does not have a pairing code. If you are prompted for one make sure you are
connecting to the correct device. If you are “forget” the device and repair. If you still
prompted enter 0000.
troubleshooting
• Do not use near any water source
• Do not modify or repair this device
• Do not use in high temperatures or extreme weather
• Do not use chemical detergents to clean your device, use a soft dry cloth
safety
Can’t get it to pair? Have a question or comment?
call us at: 877-698-4883 or: 877 - MyTgtTech online at: TargetTechSupport.com
need some help?
• Rapid Flashing White Light - Pairing mode
• Solid White - Speaker is paired
• Red Light - Charging
• No Red Light - Charging complete
• Ascending Tones - Power on
• Descending Tones - Power o
• Three Rapid Tones - Ready to pair
• Two Rapid Dings - Low battery
• Quick Ascending Tone - Max volume
• Quick Descending Tone - Min. volume
indicators
aux
port
press - vol. up
hold - next track
press - vol. down
hold - prev. track
hold - on/o
press - pair/aux mode
hold - unpair
press - play/pause/
answer/end calls
hold - reject call
top back
charge port
power
light
indicator
light
stand slot
5.9 inch