User Manual

Resetting the Answering System

After connecting your phone, press and hold down the button for at least 3 seconds.

Release the button and the unit will “beep”. Your unit will now reset itself. Then your unit will

announce, “Please enter new time and record your announcement.” You can now set the

day/time and record your new announcement. See the details in the following paragraphs.

NOTE: If the Answering System stops functioning or is not functioning normally, unplug and

then plug the AC ADAPTER into its power source. Then follow the procedure in the

preceding paragraph to reset the Answering System.

Setting the Day/Time Stamp

Press and hold down the button until you hear the announcement “Time is off, please

enter new time.” Then enter the current day and time.

1. Day Setting

Press and hold down the button. Release the button when the desired day is

announced.

2. Hour Setting

Press and hold down the button. Release the button when the desired hour is

announced.

3. Minute Setting

Press and hold down the button. Release the button when the desired minute is

announced.

Press the button to confirm the selected day and time. The system will announce the day

and time.

You must set the Day and Time in order to have a correct Day/Time stamp at the end of each

incoming message. Anytime you have a power failure or power interruption, you must reset the

Day and Time.

SET

MIN

PAGE

SET

STOP

Answering System Operation