User Manual

NOTE: To check your OGM, press the button. If you did not record an OGM, your

Answering System will announce, “You have no announcement.”

B. Recording your OGM to Individual MAILBOX 1, 2, 3 or 4

1. Press a mailbox button, the corresponding MAILBOX LED indicator will blink.

2. Press and hold down the button to record your message.

3. Begin speaking immediately after you hear, “Please record your announcement after the

beep”. Continue to press the button.

One second after completing your OGM, release the button. Your recorded message

will be played after releasing the button.

NOTE: Your OGM must be at least 3 seconds and no more than 30 seconds in length. If you

wish to change your OGM, repeat steps 1 through 3.

NOTE: To check your OGM in a mailbox, press a mailbox button and then press the

button. If you do not have an OGM in a mailbox, it will announce “You have no

announcement.” Once a mailbox is activated, its corresponding MAILBOX LED

indicator blinks slowly to show that the mailbox is active. If you do not press a button

to activate another function within 12 seconds, the Answering System will return to

the PRIMARY MAILBOX. You may return to the PRIMARY MAILBOX at anytime by

pressing the button.

Adjusting the Speaker Volume

While your Answering System play back your message, you can adjust the speaker volume by

pressing the and button. The LED Message Display will display the level you

adjusted.

“0” - Speaker off

“1~8” - Volume from low to high

Turning the Answering System ON/OFF

1. Press the button to turn ON the Answering System. You will hear the following

message, “Answering machine is ON.”

2. Press the button again to turn OFF the Answering System. You will now hear the

following message, “Answering machine is OFF.”

NOTE: Once turned OFF, the Answer function will answer only on the tenth ring, allowing

you to turn the Answering System ON from a remote location.

ANSWER

ON/OFF

ANSWER

ON/OFF

STOP

OGM

Answering System Operation