User Manual

BASE UNIT Control
1. BASE UNIT ANTENNA
2. TELEPHONE LINE CONNECTION JACK
3. RING SELECT Switch: To select the number of rings before the Answering System
answers a call.
3R - System answers a call after third ring.
5R - System answers a call after the fifth ring.
TS (TOLL SAVER) - System answers after the third ring only if you have new
message. Otherwise, the system will answer after the fifth ring.
4. TONE/PULSE Select Switch
5. RINGER ON/OFF Switch: Set switch to OFF position to disengage the ringer on the BASE
UNIT.
6. POWER-IN CONNECTION JACK
7. ANNOUNCEMENT ONLY/INCOMING MESSAGE Switch:
ICM - System records the incoming messages.
ANNC- System plays your announcement and then hangs up without recording
messages.
8. MESSAGE ALERT Switch: Set switch to ON to generate a “beep” sound every 15
seconds when a new message has been received.
IMPORTANT
Placing your BASE UNIT near appliances such as
televisions, refrigerators, radios, or microwave ovens
may cause interference.
BASE UNIT Controls
1. BASE UNIT
ANTENNA
2. TELEPHONE LINE
CONNECTION JACK
Pg. 6, 7, 10, 12, 42
6. POWER-IN
CONNECTION JACK
Pg. 6, 7
4. TONE-PULSE SELECT
SWITCH Pg. 7, 42
3. RING SELECT SWITCH
Pg. 33
8. MESSAGE ALERT
SWITCH
Pg. 33
7. ANNOUNCEMENT
ONLY/INCOMING
MESSAGE SWITCH
5. RINGER ON/OFF
SWITCH