Specifications
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.2 RF Antenna Interface
- 2.3 GNSS Interface
- 2.4 Sample Application
- 3 Operating Characteristics
- 3.1 Operating Modes
- 3.2 Power Up/Power Down Scenarios
- 3.3 Power Saving
- 3.4 Power Supply
- 3.5 Operating Temperatures
- 3.6 Electrostatic Discharge
- 3.7 Blocking against RF on Interface Lines
- 3.8 Reliability Characteristics
- 4 Mechanical Dimensions, Mounting and Packaging
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
EXS62-W/EXS82-W Hardware Interface Description
3.4 Power Supply
102
t EXS62-W_EXS82-W_HID_v01.200ee 2022-09-02
Public/ Released
Page 86 of 144
I
BATT+
1
(i.e., only
BATT+
BB
)
Average idle supply current
(GNSS on)
CAT-M1 active (UART active)
@ DRX=128
GNSS NMEA output off
68 67 mA
GPRS active (UART active)
@ DRX=128
GNSS NMEA output on
68 65 mA
1. With an impedance of Z
LOAD
=50Ω at the antenna connector, Measured at 25°C at 3.8V.
2. Measurements start 6 minutes after switching ON the module,
Averaging times:
SUSPEND mode: 3 minutes (T3324 = 3s, T3412 = 14400s)
SLEEP mode: 10 minutes, (PSM disabled, eDRX disabled)
Idle eDRX mode: 30 minutes, (PSM disabled, eDRX enabled)
Connected DRX mode: 10 minutes,
RRC connected modes: 3 minutes,
Communication tester settings: no neighbor cells, no cell re-selection etc, RMC (reference measurement channel),
SUSPEND/SLEEP (with PSM/eDRX) is enabled via AT command
3. Communication tester settings:
RMC mode, Half Duplex,
Cat M1 Channel Bandwidth: 10MHz
Modulation: QPSK.
RB setting: 1 UL RBs, 4 DL RBs
Table 21: Current consumption ratings Cat M1 (EXSx2-W)
Description Conditions Typical rating Unit
EXS62-W EXS82-W