Specifications

Cinterion
®
EXS62-W/EXS82-W Hardware Interface Description
3.4 Power Supply
102
t EXS62-W_EXS82-W_HID_v01.200ee 2022-09-02
Public/ Released
Page 92 of 144
I
BATT+
1
(i.e., only
BATT+
BB
)
Peak Current @ RRC connected
Active Transmission UL RMC,
single tone mode (1subcar-
rier),15KHz spacing
3
VBATT =2.8V
Band1, 20dBm 640 600 mA
Band2, 20dBm 640 560 mA
Band3, 20dBm 720 608 mA
Band4, 20dBm 616 608 mA
Band5, 20dBm 552 544 mA
Band8, 20dBm 608 600 mA
Band12, 20dBm 528 504 mA
Band13, 20dBm 568 544 mA
Band18, 20dBm 568 544 mA
Band19, 20dBm 568 552 mA
Band20, 20dBm 608 560 mA
Band25, 20dBm 664 568 mA
Band26, 20dBm 536 528 mA
Band28, 20dBm 536 520 mA
Band66, 20dBm 664 560 mA
Band71, 20dBm 544 480 mA
Band85, 20dBm 544 560 mA
Average idle supply current
(GNSS on)
LTE NB1/2 active (UART
active) @ DRX=128
GNSS NMEA output off
68 67 mA
LTE NB1/2 active (UART
active) @ DRX=128
GNSS NMEA output on
66 69 mA
1. With an impedance of Z
LOAD
=50Ω at the antenna connector, Measured at 25°C at 3.8V.
2. Measurements start 6 minutes after switching ON the module,
Averaging times:
SUSPEND mode: 3 minutes (T3324 = 3s, T3412 = 14400s)
SLEEP mode: 10 minutes, (PSM disabled, eDRX disabled)
Idle eDRX mode: 30 minutes, (PSM disabled, eDRX enabled)
Connected DRX mode: 10 minutes,
RRC connected modes: 3 minutes,
Communication tester settings: no neighbor cells, no cell re-selection etc, RMC (reference measurement channel),
SUSPEND/SLEEP (with PSM/eDRX) is enabled via AT command
3. Communication tester settings:
Cat NB1/2 Channel Bandwidth: 10MHz
Modulation: BPSK for 1 UL subcarrier mode, QPSK for multi-subcarrier mode
Table 22: Current consumption ratings Cat NB1/2 (EXSx2-W)
Description Conditions Typical rating Unit
EXS62-W EXS82-W