Specifications
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.2 RF Antenna Interface
- 2.3 GNSS Interface
- 2.4 Sample Application
- 3 Operating Characteristics
- 3.1 Operating Modes
- 3.2 Power Up/Power Down Scenarios
- 3.3 Power Saving
- 3.4 Power Supply
- 3.5 Operating Temperatures
- 3.6 Electrostatic Discharge
- 3.7 Blocking against RF on Interface Lines
- 3.8 Reliability Characteristics
- 4 Mechanical Dimensions, Mounting and Packaging
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
EXS62-W/EXS82-W Hardware Interface Description
3.4 Power Supply
102
t EXS62-W_EXS82-W_HID_v01.200ee 2022-09-02
Public/ Released
Page 95 of 144
I
BATT+
1
(i.e., only
BATT+
BB
)
Average
GSM idle sup-
ply current
(GNSS on)
GPRS active (UART active) @ DRX=2
GNSS NMEA output off
64
mA
GPRS active (UART active) @ DRX=2
GNSS NMEA output on
68
mA
1. With an impedance of Z
LOAD
=50Ω at the antenna connector, Measured at 25°C at 3.8V.
2. Measurements start 6 minutes after switching ON the module,
Averaging times:
OFF mode: 3 minutes
SLEEP and IDLE mode - 10 minutes
Transfer modes - 3 minutes
Communication tester settings: no neighbor cells, no cell re-selection etc,, RMC (reference measurement
channel).
SLEEP (power save) mode is enabled via AT command
3. The power save mode is disabled via AT command
Table 23: Current consumption GSM (EXS82-W only)
Description Conditions Typical
rating
Unit