FEDERAL COMMUNICATIONS COMMISSION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for 8 Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection.
Fast Ethernet Card This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet apparel numeric de Ja Class B respect routes les exigences du Regalement sur le materiel derailleur du Canada. CE Compliance Statement We hereby certify that the PCI Ethernet adapter complies with the EN 50081-1 and EN 50082-1 requirements.
CONTENTS FCC Compliance Statement CE Compliance Statement Section 1 Introduction Section 2 Card installation ao Section 3 Configuration and Diagnostic Section 4 Drivers installation eu Section § BOOT ROM Installation Section 6 Card Specifications Section 7 Understanding the status LED
Fast Ethernet Card Section 1 Introduction Your PC-based adapter is a Fast Ethernet PCI adapter that implements the 32-bit wide, and bus mastering interface. The Fast Theme PC) adapter is based upon Industry Standard PCI focal bus specification revision 2.0, hat features the function, making it fully auto configurable. The Fast Ethernet PCI adapter isa dual-speed adapter connected to an Ethernet network with a single connection giver shielded twisted-pair (UTP) cable.
Section 2 Card Installation This section describes how to install your Ethernet adapter. Perform the following steps to install the adapter. _ Turn off your computer and all peripherals. Make a note of the cables and cords that are connected to the computer and disconnect them. . Remove your personnel computer's cover (refer to {he owner's manual of your personal computer). 4. Select any available bus mastering PCT sot, and remove the slot cover.
Fast Ethernet Card Er Section 3 Configuration and Diagnoses Your Theme adapter is automatically configured when You power-up your computer, In certain computers, however, you must modify your BIOS by entering your COS SETUP utility. To view the configuration parameters assigned by the BIOS, insert the software diskette into your drive and execute the utility software, by typing EXERTS.
Fast Ethernet Card Section 4 Drivers Instillation Before you connect your Fast Ethernet PCI adapter to the network, you have 10 install the network driver first. You should use the network driver supplied by the software diskette that is compatible with your Network Operating Systems. The network driver for each Newark Operating System is under a separate directory. Each directory includes READMITTED file to describe the detailed installation procedures.
Fast Ethernet Cara ee er Card Section 5 BOOT ROM Installation The optional BOOT ROM device allows You to connect leaderless workstation to the network. Perform the following Steps 16 install your BOOT ROM device, I. Insert the BOOT ROM into the socket on the adapter. 2. Execute the EXERTS {He to enable the BOOT ROM function by selecting the appropriate BOOT ROM address from the configuration menu 3. Refer to the installation Procedure provided by your Networking Operating System.
Fast Ethernet Card Section 6 Card Specifications IEEE 802.3 standards: ‘Wiring Connector: Bus Characteristics: YO address: Airline: Dimensions: Emission Compliance: Immunity Compliance: Power Consumption: Operating Temperature: Operating Humidity: ABASE-T and 100BASE-TX RIO 32 bits bus master; PCI local bus revision 2.0 Assigned by the BIOS to a free LO address block NTA; assigned by the BIOS 10 a free IRQ (interrupt) number 4.72" x 2.
| Fast Ethernet Card | | Section 7 Understanding the status LED Indicators | The green 100 Bps LED and green LNK LED indicate the connecting status on the port for either speed. LED State Description LNK 100 Off «No connection between adapter and hub Qn On Good [00BASE.TX connection between adapter and hub On Off Good ABASE-T connection between adapter and hub Activity Indicator The green ACT LED indicate traffic status on the port for either speed.