Network Router User Manual

ManualsBrandsCisco Systems ManualsNetwork Router827-4V

Copyright © 1999-2005 Go2Call.com, Inc. and/or its suppliers. All rights reserved. “Go2Call” and all associated logos are trademarks, registered as applicable, of Go2Call.com, Inc., and may not be reproduced without Go2Call’s permission. Other product

and company names herein may be the trademarks of their owners. This document is provided “as-is” by Go2Call.com, Inc. for the user’s internal and non-commercial use. Go2Call.com, Inc. does not promise that the information herein is accurate or

complete and all use of such information is solely at the user’s risk. All warranties disclaimed.

page 1 of 4

This le provides instructions for setting up Cisco 827-4V Router and SIP for Go2Call service.

The following example uses Cisco 827-4V gateway with four FXS/FXO ports and SIP protocol. Prior to

the conguration, you must obtain:

-IP address and Internet service from your local ISP provider

-Account with Go2Call and up to 4 different PIN number

-Cisco 827-4V with all necessary voice cards and modules

STEP 1 Connecting to the PC

Use the blue console cable and DB-9 adaptor. Connect one end of the cable to the Console port on the

router, and the other end with DB-9 adaptor to COM 1 or COM2 port on PC.

Cisco 827-4V Router Conguration

With SIP for Go2Call Service

STEP 2 Terminal Programs

Start any terminal program on the PC (for example, Hyper Terminal). Use the following terminal Settings:

9600 baud rate

No parity

8 data bits

1 stop bot

No ow control

This will power up the router. You will know it has booted up successfully if your receive this prompt:

Router>

Summary of content (4 pages)

PAGE 1
Cisco 827-4V Router Configuration With SIP for Go2Call Service This file provides instructions for setting up Cisco 827-4V Router and SIP for Go2Call service. The following example uses Cisco 827-4V gateway with four FXS/FXO ports and SIP protocol.
PAGE 2
Cisco 827-4V Gateway Configuration With Go2Call Prepaid Voice Service STEP 3 General Set-up To configure the General set-up of your device, enter the following command: Router> enable Router# config terminal Router(config-t)# enable secret password ßThis is to set up a password. Change “password” with any word that you want to use for a password. Router(config-t)# hostname R1 ßSet up the prompt for the router. Change “R1” to any name.
PAGE 3
Cisco 827-4V Gateway Configuration With Go2Call Prepaid Voice Service STEP 5 Enabling VoIP To enable VoIP, copy and paste the following output once you are in config-t mode: R1(config-t)#. These are the changes that need to be made: YourGwName ßReplace with your Gateway name or Company name. 12345678900x ßReplace with your PIN number. X.X.X.X ßReplace with your IP address from the Ethernet port. ** If your Cisco 827-4v has a public ip address then use: session target ipv4: 216.52.153.
PAGE 4
Cisco 827-4V Gateway Configuration With Go2Call Prepaid Voice Service Continued: dial-peer voice 1 pots port 1 ! dial-peer voice 2 pots port 2 ! dial-peer voice 3 pots port 3 ! dial-peer voice 4 pots port 4 ! dial-peer voice 100 voip destination-pattern 723 session protocol sipv2 session target ipv4:216.52.153.