- Cisco D9865 Satellite Receiver Manual

4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide 4-5
Main Menu, Continued
About using the on-screen menus
All screens or menus are accessed from the Main Menu. While viewing any
channel, you can display on-screen menus for viewing or changing the current
receiver setup. While in menus, you can change the current receiver settings, and/
or display other menus. Some menus contain status information, which is available
for viewing only and cannot be changed.
To change a setting on a menu using the remote control:
1. Use the
 buttons to move to the setting you want to change.
2. Press the OK button to select the setting.
3. For numeric options, you can use one of the following methods:
• enter the number directly using the numeric keypad on the remote control,
•use the
 buttons to change the value one digit at a time, or
• press the red button (keyboard) to use an on-screen keyboard.
4. Press OK to save the setting and exit the menu. A help message is displayed at
the bottom of the screen.
5. Press MENU to move to the previous menu.
Note: The steps in this chapter are based on using the remote control. For more
information on changing a setting on a menu using the front panel controls, see
About the Front Panel, on page 3-2.
The On-Screen Buttons
The on-screen menus have the following common buttons:
About the Current Channel
When you navigate to menus from a video channel, the information displayed is
associated with the current (video) channel. If no changes have been made to the
current setup, you are automatically returned to the same video channel when you
exit to video.
Button Description
Save Saves and applies the settings to the
receiver.
Exit Exits edit mode and menu. A message
prompts you to save or discard changes
before you exit the menu.