- Cisco D9865 Satellite Receiver Manual

4-62 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C
Setting up Trap Destinations, Continued
Adding Trap Destinations
Proceed as follows to add trap destinations:
1. From the Trap Destination Setup screen, press the green button (Add) to add a
trap destination address.
2. The following table describes each of the available options:
3. Click the green button (Save) to save the changes.
Editing/Deleting Trap Destinations
Proceed as follows to edit/delete trap destinations.
1. In the Trap Destination Setup screen, select the trap destination address you
want to edit or delete and press OK.
2. Press the blue button (Edit) to edit the address. Press the red button (Delete) to
remove the address from the Trap Destination list.
3. If you pressed the blue button, you can edit the Trap Destination Address and
Community String and press the green button (Save) to save your changes.
4. If you pressed the red button (Delete), a warning message appears. Press OK to
delete the selected trap destination entry. Otherwise, press Exit.
Selection Options Description
Trap Destination
Address
Up to 12 digits in
length (e.g.,
155.128.100.200).
Enter the destination for SNMP trap
messages for events (i.e., fault
messages).
Community String public or custom
string. Up to 31
characters
Set the community string for the trap IP
address above. The default is public.