Switch User's Manual

10
Catalyst 6000 Family Multilayer Switch Feature Card 2 Installation Note
78-10605-03
Installing the MSFC2
Figure 3 Removing Securing Screws and Cap Nut
Step 4 Hold the top edge of the MSFC with your right hand and the bottom-left edge with your left hand
(see Figure 3). Gently lift the MSFC with both hands simultaneously and remove the MSFC from the
supervisor engine.
Caution Use care not to damage the connectors on the supervisor engine. If you damage a connector, you will
have to return the supervisor engine to Cisco for repair.
Step 5 Place the MSFC on an antistatic mat or antistatic foam pad.
Installing the MSFC2
Note The MSFC2 is designed to be installed on a Supervisor Engine 1A and a Supervisor Engine 2.
The standoff locations on the different supervisor engines may not be the same. Not all mounting
holes on the MSFC2 will be used in all installations. Visually verify that there are standoffs beneath
the mounting holes before installing the securing screws.
24069
SUPERVISOR ENGINE I I I
CONSOLE
SWITCH LOAD
1%
100%
AC
TIVE
ACTIVE ACTIVE
RESET
SLOT 0
SYSYEM
STATUS
WS-X5530
cap nut
Hold here
Hold here