Datasheet

Installing 2T16S Network Processor Modules in the Cisco 4000 Series

78-3277-03

Step 2 Grasp the network processor module handle and pull it straight up to lift the module out of its connector.

(See Figure 6.)

Step 3 Place the removed module on an ESD mat.

Caution Do not wiggle the handle of the network processor module, and do not exert any side-to-side pressure

because the handle might work loose and damage the network processor module.

Figure 6 Cisco 4000 Series Component Tray—Cisco 4000-M Shown

Caution If any of the network processor modules have daughter cards projecting at right angles to the module

(see Figure 10), do not bend the module during installation. Bending the module might cause the

daughter cards to become disconnected. If this happens, carefully reseat the daughter card connectors by

handling the card by its edges without touching any of the components on the card.

FW1

FW2

LEDs

Boot ROMs

Module

mounting

screws

128-pin connector

H8643

Front

of the

chass

LED

Module handle