Datasheet

Installing 2T16S Network Processor Modules in the Cisco 4000 Series

78-3277-03

Figure 23 Cable Support Tray Mounted on Chassis

Attaching U-Shaped Cable Clamps to the Cable Support Tray

Use the U-shaped cable clamps to route wires from the high-speed and low-speed ports on your 2T16S

network processor modules. To attach cable clamps to the cable support tray, follow these steps:

Step 1 Align the hole in the center of the U-shaped cable clamp with a hole in the cable support tray and insert

the rivet through both holes. (See Figure 24.)

Step 2 Holding the U clamp steady on top of the cable support tray, insert the rivet through the U clamp and the

hole in the cable support tray.

Step 3 Press the top of the rivet firmly enough for the rivet to lock in place.

The rivet locks automatically and holds the U clamp to the cable support tray. (See Figure 25.)

Step 4 Pass wires from the high-speed and low-speed serial ports through the U clamp. (See Figure 25.)

SERIAL

AUI

LNK

POL

AUI

LNK

POL

10BASE-T

PORT-0

PORT-1

SERIAL

H7879