Datasheet

Installing 2T16S Network Processor Modules in the Cisco 4000 Series

78-3277-03

Figure 25 Routing Serial Wires from the 2T16S Network Processor Module through the U Clamp

Removing the U-Shaped Cable Support Clamp from the Cable Support Tray

You can remove U-shaped cable support clamps or move them to another location on the cable support

tray. To remove a U clamp, push up on the center rivet pin from under the cable support tray. (See

Figure 26.)

Timesaver If you push on the protruding rivet legs from the underside of the cable support tray, the rivet does not

come loose. Use a sharp object to push the center rivet pin up through the cable support tray and

U-shaped cable support clamp.

H8750