Datasheet

Installing 2T16S Network Processor Modules in the Cisco 4000 Series
34
Installing 2T16S Network Processor Modules in the Cisco 4000 Series
78-3277-03
Step 3 Attach the EIA/TIA-232, V.35, or X.21 end of the cable to the CSU/DSU or modem. (See Figure 29 on
page 34.)
Step 4 Repeat Steps 1 through 3 for each low-speed serial connection you are making. For cable routing, see
Figure 30 through Figure 33 (page 35 through page 38).
Step 5 If all your network connections are complete, proceed to the section “Connecting the Power Cord and
Switching on the Router” on page 39.
Caution Make sure that the 200-pin end of the cable connector is orientated correctly before plugging it in. Cable
connector pins can be easily damaged.
Figure 29 Making Low-Speed Serial Connections to the 2T16S Network Processor Module
Router
(rear view)
2T16S network processor module
AUX
Serial port
200-pin connector
Modem or
CSU/DSU
Low-speed
serial ports
17
SERIAL
16
1514
1312
11
10
9
8
76
54
3
P1
2
P0
EIA/TIA-232, V.35,
or X.21 connector
H6441