Owner`s manual

AccessLine Communications

Owner’s Manual AccessLine 3-9-11

4. Place the Handset into the charging cradle. The light on the

charging cradle appears solid green when the Handset is

charging. Charge the Handset for a minimum of 10 hours

before using the Handset for the first time to ensure that the

Handset is fully charged.

Note

If the batteries are charged, the Handset turns on when the

batteries are inserted. If the batteries are not charged, the

Handset turns on when it is placed into the charging cradle

Turning On Cordless Handset

Each Cordless Handset and Cordless Base purchased from

AccessLine will be pre-registered and configured. Additional or

replacement Cordless Handsets will need to be manually

registered (see Manual Phone Registration). The Cisco Cordless

Handsets will be shipped with the batteries pre-installed.

1. Install and configure the Cisco Cordless Base. See the Cisco

Cordless Base instructions above for more information. Cordless

Base SYSTEM and INTERNET lights should be lit.

2. On the Cisco Cordless Handset, press and hold the End Call

button for 5 seconds.

3. Release the End Call button and wait up to 10 seconds

for the screen to illuminate.

4. If screen does not illuminate verify batteries are installed

correctly and charged and repeat steps 1-3.

5. Handset screen will first display date and time, followed by

steady signal strength indicator then finally the Handset phone

number.

Registering a Cordless Handset

Each Cordless Handset purchased at the time the Cordless Base

is purchased will be pre-registered. Additional or replacement

Cordless Handsets will need to be manually registered:

Install and configure the Cisco SPA232D. See the Cisco

SPA232D Quick Start Guide for more information.