Owner`s manual

AccessLine Communications
Owner’s Manual AccessLine 3-9-11
19
1 On the Cisco SPA302 Handset, press the Select button
in the center of the 4-way navigation keypad.
2 Using the navigation arrow buttons, scroll to the Settings
icon and press the center Select button to select it.
3 Select Handset Registration.
4 Select Register.
5 On the Cisco SPA232D, press the Page/Registration
button (shown below) and hold it down for at least
seven seconds until the green status light flashes
quickly.
6 Enter the Handset PIN when prompted.
Note: You will need to call Customer Service to retrieve the
Handset PIN required for subsequent registrations.
7 Press the Confirm soft-key.
TIP: If you press the button for fewer than seven seconds, the
green status light flashes slowly, indicating the unit is in “paging”
mode and is not in registration mode.
Registration will not work if the unit is in paging mode.
Note: You will need to call Customer Service to retrieve
the Handset PIN required for subsequent registrations.