Owner`s manual

AccessLine Communications
Owner’s Manual AccessLine 3-9-11
23
Getting Started
The Cordless Handsets and Cordless Base are shipped to you pre-
configured. You do not have to do any configuring or programming of
the Cordless Handset. Each Cordless Handset has been assigned a
phone number and extension number. This section describes the
function of the lights on the Cordless Base and some of the initial
phone startup screens.
Cordless Base Basics
The Cordless Base provides wireless connectivity to the Cordless
Handsets. The Lights on the top of the Cordless Base indicate the
current status. After the initial installation and activation, the
SYSTEM and INTERNET lights should remain lit.
The following describes the indicator lights, ports and buttons on the
Cordless Base which, in turn, provides information on the operating
state.
Feature
Description
SYSTEM
Steady green—The system is ready.
Slow flashing green—Acquiring an IP address, if
applicable. (DHCP is used by default.)
Fast flashing green—Upgrading the firmware.
Off—There is no power or the system cannot boot up.
INTERNET
Flashing green—Transmitting or receiving data
through the WAN port.
Off—No link.