Owner’s Manual
9
99
I
N AV I G AT I O N / G U I DA N C E
G E NE R A L
WHAT YOU NEED TO DO IN ORDER TO
USE THE NAVIGATION SYSTEM ?
You have to initialise the navigation system:
when you fi rst use the navigation
following a battery disconnection.
Park the vehicle in the open air so that it can
make contact with a satellite.
Place the ignition key in the “Ignition” position
for 15 minutes.
If the navigation system has diffi culty in
receiving its GPS positioning from satel-
lites, this may be caused by the presence
of bridges, underground carparks, etc.,
which may temporarily interfere with vehi-
cle location or guidance calculation.
•
•
WHAT IS THE NAVIGATION SYSTEM ?
The on-board navigation system uses audible
and visual instructions to guide you towards
the destination of your choice.
The system uses GPS and a mapping data-
base stored on a hard disc.
The GPS system enables your position
to be plotted via contact with a number of
satellites.
The navigation system is composed of the
following elements:
A synthesised voice for enunciating the
guidance instructions during navigation.
A multifunction display.
A GPS aerial.
Controls on your NaviDrive as well as on
the steering wheel.
•
•
•
•
The demonstration gives you a simulation
of the Navigation function.
The demonstration only operates if the
Navigation function is displaying
(
suc-
cessive
presses on button MODE).
Keep the MENU button pressed.
Enter a destination (see “How to enter
an address ?”).
Launch Navigation to start the demon-
stration.
The departure point will be either the current
location of the vehicle or the last location
known.
•
•
•
If your NaviDrive should malfunction, press for at least 10 seconds on the DARK button to re-initialise the system.
HOW TO ACTIVATE A NAVIGATION
SYSTEM DEMONSTRATION ?
You can use the demonstration menu to enter a different point of departure to where you are now.
This lets you plan a trip that you are wishing to make.