Owner’s Manual

II
38
Guide-me-home lighting
A press on button C operates the
guide-me-home lighting (illumina-
tion of the sidelamps and dipped
beams for approx. one minute).
A second press prior to the end of
this timing cancels the guide-me-
home lighting.
Locating of the vehicle
To locate the vehicle on a carpark,
press button A, the interior lamps
come on and the direction indica-
tors flash for a few seconds. The
vehicle remains locked.
Folding and ejection of the key
Button D is for folding and eject-
ing the key from its housing in the
remote control.
If you do not press on button D,
you could damage the mecha-
nism.
Except when reinitialising, the remote control cannot function
while the key is in the ignition, even when switched off.
Warning: By inadvertently actioning the remote control, when for
example it is in your pocket, you can unlock the vehicle without
your realising it.
However, if none of the doors is opened within thirty seconds
following an unlocking, the doors will automatically relock.
Warning: There a is a risk of damage if the replacement battery is
not the correct one.
Only use batteries that are identical or equivalent to those
approved by CITROËN.
Changing the remote control battery
Unclip the cover to gain access to the battery.
Battery: CR 0523: 3V.
Re-initialisation of the remote control
After a change of battery, it is necessary to re-initialise the remote control.
To do that, switch on the ignition and immediately action button A on your
remote control to trigger the action desired. This may take some ten sec-
onds.
Note: Make a careful note of the numbers for the keys and for the remote
control on the ASSISTANCE card. Keep this in a safe place.
Do not throw away the old batteries. They should be returned to the
CITROËN dealer or deposited in a recognised recycling facility (cam-
era shops etc.).
R E M O T E C O N T R O L
Take care not to place the
remote control in contact
with grease or dust, or leave
it in the rain or in a damp
environment.
A hard object also on the
key ring, pressing on the key
while it is in the ignition, can
cause a malfunction.