Use and Care Manual

SET UP INSTRUCTIONS CONTINUED
Step 7 (optional): Insert the vertical rods on either
side of the screen tent’s door. Remove the Velcro
retaining loop securing the pole to the adjacent wall.
Once freed, install one end of the rod into the
other’s end to make it one long rod. Place the
bottom of the rod in the pocket located at the
bottom of the panel directly below where the rods
are mounted. Secure the rod with the Velcro loop.
Repeat on the other side. It is recommended to use
these if any wind is present. (Photos 6 & 7)
Step 8: Install securing stakes on the tent. The stakes
are designed to be used on the inside grommets or
the outside tie downs. If there is little to no wind,
stakes may be used in the eyelet in each corner of
the screen tent. Place the tip of the stake on the
inside of the eyelet and drive it into the ground so
the hook catches the eyelet and holds the tent in
place.
If wind is present you must use the outside tie
downs. Secure the tent by tying one end of the
provided strings on each metal loop on the outside
of the hub and staking the other end. (Photo 8)
Using the built in Wind Panels:
Step 1: Locate the tie strings mounted on each end
of the wind panels. Untie and let the panel fall down.
Step 2: Locate the hub strap on the center of the wall
and pull it through the grommet on the wind panel.
Step 3: Zip down the zippers located on each side of
the wind panels. Finish with securing the Velcro tabs
on the outside of the zipper.
Step 4: To store the wind panels, simply detach the
Velcro tabs and unzip the wind panels. Roll the panel
back up and tie with tie strings.
Photo 6
Photo 5
Photo 8