Use and Care Manual

Photo 1
Step 1: Remove all the stakes from the interior and
exterior of the tent.
Step 2: If used, remove the vertical door support rods
from pockets at the bottom of the panel, pull apart, and
refasten them with the Velcro straps located diagonally
on the panels next to each side of the door. (Photo 1)
Step 3: Push in on the walls in from the outside of the
tent to collapse the wall panels. Do this to all wall
panels until the tent is collapsed. (Photo 2)
Step 4: Push down on one of the roof poles until the
roof is collapsed. (Photo 3)
Step 5: Once the shelter is completely collapsed grab
one corner of the tent and fold it in half on itself. Once
in half, you can now condense the shelter to fit into the
carry bag. (Photo 4)
Step 6: Carefully lift and insert into the carry bag. Pay
close attention not to twist or distort the hubs or fabric
while inserting into bag. Place stakes and tie down
ropes into their bag and place the stake bag into the
carry bag.
TAKE DOWN INSTRUCTIONS
Photo 2
Photo 3
Photo 4