Warranty

Page 6
SET-UP INSTRUCTIONS
6. Secure the vertical rods on either side of the screen
tent’s door. Remove rods from Velcro retaining loop on
either side of the door. W hen free, install one end of the
rod into the other’s end to make one long rod. Once the
rod has been assembled, place the bottom of the rod in the
pocket or sleeve located at the bottom of the panel directly
below where the rods are mounted. Once the rod is
installed into the pocket, secure the rod with the Velcro
loop just above waist level on the panel(2x).
7. Install securing stakes on the interior of the screen tent.
In each corner of the inside of the screen tent’s panels there Is
an eyelet. Place the tip of a stake inside the eyelet and step
down on it driving it into the ground so that the hook catches the
eyelet and holds the tent in place(6x). On windy days, secure the
outside of the tent by tying one of the tie strings on each of the
pull loops on each panel, then pull snug and attaching it to a stake
by making a loop in the cinch clip that the stake hook will catch,
and then drive the stake into the ground approximately 3 to 4 feet
from the outside wall.