Owner`s manual

9. III CASE OF DIFEICULTY
% ,,.: ~ ,,;>;
File system is not correct. Use 1809660 level 1, 2, 3 or JOLIET or Romeo file system.
I
Use 1809660 level 1, 2, 3 or JOLIET or Romeo file system.
Use MP3IWMA files encoded properly.
Use MP3IWMA files encoded properly.
Replace with a fuse of the same amperage.
If the
fuse blows again, consult your store of purchase.
Replace with a compact disc with no scratches.
Consult your store of purchase.
Write MP3IWMA files onto the disc properly.
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
Reset button
Clean the compact disc with a soft cloth.
1. Turn the unit off.
2. Remove all wires attached to the power antenna
lead. Check each wire for a possible short to
ground using an ohm meter.
3. Turn the unit back on.
4. Reconnect each amplifier remote wire to the
power antenna lead one by one. If the amplifiers
turn off before all wires are attached, use an
external relay to provide remote-on voltage
(excessive current required).
Turn off the power, then press
the
[RELEASE] button and
remove the
DCP.
Press the reset button for
about 2 seconds with a thin
rod.
Compact disc
is heavily
scratched or warped.
Water droplets may form on Let
dry for about 1 hour with the power on.
the internal lens when the
car is parked
in a humid
place.
Compact disc
is dirty.
File name
or extension is not Use alphanumeric/ASCII characters for MP3IWMA file name.
correct. Use ".M3U" or ".ASX" for the file extension of a play list.
DCP or source unit
connectors are dirty.
MP3IWMA files are not
encoded properly.
File system is not correct.
MP3/WMA files are absent
in a disc.
Files are not recognized as
an MP3IWMA file.
Incorrect wiring.
The microprocessor has
malfunctioned due to noise,
etc.
Power antenna lead is
shorted to ground or
excessive current is required
for remote-on the amplifiers
or power antenna.
Sound is cut
or
skipped.
Noise is
generated or
noise is mixed
with sound.
No sound output
when operating
the unit with
amplifiers or
power antenna
attached.
DXZ635MP 27