Instruction Manual

FORM-ENG-0018 REV A 05-27-03
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : [phone] or 1-800-520-3473
TECHNICAL DATA SHEET
PAGE
2 OF 26
DATE
3/28/2012
PRODUCT GROUP
THROTTLE CONTROL
P/N 117155 REV
1.23
PRODUCT
TOTAL PRESSURE GOVERNOR (TPG)
BY AMS
Manual P/N 117684
5.2.19. DISPLAY (primary display in pressure mode) ............................................................................ 18
5.2.20. PSI TIME-OUT (pressure time out) ............................................................................................. 18
5.2.21. ALLOW PRESET (allow RPM preset use when pressure is detected) ...................................... 18
5.2.22. WARNINGS (data monitor warning configuration) ..................................................................... 19
A. WARN ºF (User defined engine temperature high warning - Yellow LED).......................................................19
B. CRIT ºF (User defined engine temperature high critical - Red LED) ...............................................................19
C. WARN PSI (User defined oil pressure low warning - Yellow LED) ..................................................................19
D. CRIT PSI (User defined oil pressure low critical - Red LED) ...........................................................................19
5.2.23. XDUCR (discharge pressure transducer range) ......................................................................... 19
5.2.24. FACTORY DFLT (Set factory defaults) ....................................................................................... 19
5.2.25. POC ASSERT (Power On Cycle assertion) ................................................................................ 19
5.2.26. GOV GAIN (RPM change per step) ............................................................................................ 19
5.2.27. PRESS GAIN (PSI change per step) .......................................................................................... 19
5.2.28. DITHER (Engine handshake)...................................................................................................... 20
5.2.29. LAG ∆PSI (Pressure lag) ............................................................................................................ 20
5.2.30. PUMP HOURS ............................................................................................................................ 20
5.2.31. BCM1 VER (Body Control Message 1 version) .......................................................................... 20
5.2.32. SCANIA MODE? (Scania governor type) ................................................................................... 20
5.2.33. IDLE STEPS (Analog control idle) .............................................................................................. 20
5.2.34. OKAY2PUMP (Okay to pump interlock source).......................................................................... 20
5.2.35. SPN 3350 (TSC1 – SPN 3350) ................................................................................................... 21
5.2.36. SPN 696 (Engine Requested Speed Control Condition) ............................................................ 21
5.2.37. HI IDLE MODE ............................................................................................................................ 21
5.2.38. BUS INTLKS (Bus message control of throttle ready interlock) ................................................. 21
5.2.39. VOLTS (Voltage display calibration) ........................................................................................... 21
5.2.40. SMOOTHING (Pressure display averaging) ............................................................................... 21
5.2.41. ENGINE ID (Source ID of received engine messages) .............................................................. 22
6. SPECIAL FUNCTION PASSWORDS (SEE SECTION 5.2 FOR PROCEDURE ON ENTERING
PASSWORDS) ...................................................................................................................................................... 23
6.1. SETTING CONTROL MESSAGE TRANSMISSION REQUIREMENTS ................................................................... 23
6.2. SETTING CONTROL FOR SPECIFIC ENGINE TYPES ...................................................................................... 23
6.3. CONFIGURING TRANSMISSION OF HYDRAULIC PRESSURE GOVERNOR MESSAGE ........................................ 23
7. CONFIGURATION ..................................................................................................................................... 24
7.1. CONFIGURE THE UNIT OF MEASURE ......................................................................................................... 24
7.2. SELECT PRESSURE TRANSDUCER RANGE (300 PSI, 600 PSI) .................................................................. 24
7.3. ZERO CALIBRATE THE PRESSURE TRANSDUCER ....................................................................................... 25
7.4. CONFIGURE THE ENGINE CONTROL METHOD ............................................................................................ 25
7.5. CONFIGURE THE IDLE VOLTAGE AND GAIN SETTING USING AUTO SCALE ................................................. 26
8. MOUNTING & INSTALLATION ................................................................................................................. 27
8.1. PANEL CUTOUT DIMENSIONS ................................................................................................................... 27
9. CONNECTOR DESCRIPTION................................................................................................................... 28
9.1. TPG CONNECTORS ................................................................................................................................ 28
9.2. PRESSURE SENSOR CONNECTOR ............................................................................................................ 28
10. MODULE OPERATING PARAMETERS ................................................................................................... 29