Owner's manual

11
Solid State Modules use an integrated circuit driver to supply current to its loads. Outputs are
common bussed to system power and can deliver up to 7.5 Amps. Current levels above two
(2) amps can be used to indicate whether an output is ON or OFF. These modules use a Hex
switch for addressing and come in three (3) styles.
104434 Eight (8) output PDM-8
104528 Six output Two input PDM-(6/2)
104529 Four output Four input PDM-(4/4)
Solid State Modules with inputs have polarity selectable inputs.
Any output can be made to flash, the first four inputs flash at one instance and the second
four flash at the opposite instance (anti-flash).
The flash rate can be configured to 75 FPM or 150 FPM.
Connector Information
DTM06-12SA Lock WM-12S
Deutsch 20 Ga Sockets
1062-20-0122 for 16-10 Ga wire
0462-201-20141 for 18-24 Ga wire
0462-201-2031 Gold Contacts 18-24 Ga wire
PWR
BUS
COM
7 8 9 10 11 12
6 5 4 3 2 1
Power Modules
Eight Output Six OUT/Two IN Four OUT/Four IN
1 Output 0 1 Output 0 1 Output 0
2 CAN HI 2 CAN HI 2 CAN HI
3 CAN Shield 3 CAN Shield 3 CAN Shield
4 Output 2 4 Output 2 4 Output 2
5 Output 4 5 Output 4 5 Input 3
6 Output 6 6 Input 1 6 Input 1
7 Output 7 7 Input 0 7 Input 0
8 Output 5 8 Output 5 8 Input 2
9 Output 3 9 Output 3 9 Output 3
10 Output 1 10 Output 1 10 Output 1
11 CAN LO 11 CAN LO 11 CAN LO
12 Ground 12 Ground 12 Ground
Power Stud 10-32 thread/#10 Ring