Use and Care Manual

4
NO TOOLS NEEDEDPARTS NEEDED
1
ASSEMBLE THE FRAME
2
ASSEMBLE THE HOOP
ASSEMBLY AND INSTALLATION
A
B
B
E
E

Insert vertical posts [E] into the main frame bar [A] making
sure the notch in the post is at the top.

Insert main frame legs [B] into the main frame [A] until the spring
button pops through hole in the main frame bar.

While grasping both ends of
the assembled hoop, insert
poles into the ends into the
vertical posts [E].

Grasp the hoop pole assembly
by the outside set of poles and
bend into a curve.

Lay the fiberglass rods on a flat surface to assemble.

Connect the seven hoop rods [H], [I], [F],[G] together as shown.
The plastic PVC sleeve of rod [F] must attach to rod [G].
E
H
E
H
H
H
I
F
G
I
F
G
F
I
H
Plastic PVC Sleeve
WARNING! Use care when assembling the fiberglass
rods. Under tension they can slip out of the metal/PVC
sleeves causing serious injury. Safety goggles
are recommended.
+
A
E
B
G H
F
I
Note: Make sure that fiberglass rods are fully seated in
neighboring plastic PVC sleeves when joined together.