Use and Care Manual

5

Slide the top
pocket of the
fabric shell
[Q] over the
installed hoop
assembly.

Secure the skin to the frame with the sewn-in rip-n-grip strips (5 total).

Assemble .75" mounting post upper clamp
[K] to the top plate [L] on the forward edge
of the frame [A]. Secure with two washers
[S] and two hex bolts [Q].

Repeat with the other mounting post set on
the opposite side of the frame.
ASSEMBLY AND INSTALLATION
TOOLS NEEDEDPARTS NEEDED
Note: Fabric skin will be tight when properly assembled.
Note: When attaching the rip-and-grip strip, push the frame up while
pulling the strip around the frame to increase tension in the shell.
+ +
Q
3
INSTALL THE CAB SKIN ONTO THE FRAME
4
SECURE THE FABRIC SKIN TO THE FRAME
5
INSTALL MOUNTING
POSTS ON CAB FRAME
Q
(Snow cab skin not shown for visibility.)
K
Q
S
S
L
A
5
2
3
4
1
1/2 in. Box
Wrench
OR
OR
1/2 in. Socket
Wrench
Adjustable
Wrench

Pull down the lower corner of the
shell and slide over the end of the
side frame bars [B].

Repeat with the other elastic corner,
making sure frame is secure in
elastic pocket.
K
L
S
Q
(2 each)