Indoor Fireplace User Manual

SECTION 7: MAINTENANCE
E-8
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs or
rewiring of this unit should be carried out by a licensed electrician in accordance with
national and local codes.
WARNING: Electrical outlet wiring must comply with local building codes and other appli-
cable regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately call
a qualified service technician to inspect the fireplace and replace any part of the electrical
system.
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce
the risk of fire, electrical shock or personal injury.
The motors used on the fan and the flame gen-
erator assembly are pre-lubricated for extended
bearing life and require no further lubrication.
However, periodic cleaning/vacuuming of the
fan/heater unit is recommended. The vent in the
for the heat output should be cleaned periodically.
The area around the controls should also be kept
clean. Make sure the unit is turned OFF whenever
you are cleaning the heater or fireplace.
If repairing or replacing any electrical component or wiring, the original wire routing, color coding
and securing locations must be followed.