Instructions

MWG778U_IM_D_F_I_GB_new3 30.07.21
46
Example: 7:30 minutes cooking time at 80 % power; start time
14:20 o’clock
Step Button / Rotary Knob Display
1 MICRO. / GRILL / COMBI.
(Selection)
2
(Power setting)
3 MICRO. / GRILL / COMBI.
(Conrmation)
4
(Cooking time)
5 CLOCK / PRE-SET
(Current time)
6
(Set hour)
7 CLOCK / PRE-SET
8 (Set minutes)
9 QUICK START / START
(Current time)
NOTE:
• During this programmed setting the functions of the controls are
blocked (except: CLOCK / PRE-SET and CANCEL / STOP).
• If you wish to display the start time again, press the button
CLOCK / PRE-SET.
• When the pre-set time has been reached, the microwave will start
operation. Two signal tones will indicate the start.
WARNING: RISK OF FIRE!
• Always supervise the appliance during operation.
• When using the time-delay function, set the time in such a way
that the appliance will be operating under proper supervision.
• Do not operate the microwave empty.
• If you take the food earlier from the appliance, you will have to
terminate the function by pressing the CANCEL / STOP button.
Locking (Child-Proof Lock)
Press and hold the CANCEL / STOP button for more than 3 seconds
to lock the appliance. The display will show the locked setting.
The functions of the controls are blocked. Press and hold the
CANCEL / STOP button again for more than 3 seconds to unlock.
Display Function
• During microwave, grilling or combined operation you can press the
MICRO. / GRILL / COMBI. button for 2 – 3 seconds in order to show
the current power level.
• In disregard to the operation mode, the display will be showing the
current time for 2 – 3 seconds when pressing the CLOCK / PRE-SET
button.
• During time-delay mode, press the CLOCK / PRE-SET button to
display the start time.
Cleaning
WARNING:
Turn the microwave off and remove the mains plug.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Do not use a metal scraper to clean the viewing window. The
surface could be scratched and the glass could possibly break.
Interior
• Keep the interior of the oven clean. Splashes and overowing
liquids on the walls of the oven can be removed with a damp cloth.
If the oven is very dirty a mild detergent can also be used.
• Wipe off the viewing window on the inside and outside with a damp
cloth and remove splashes and stains from overowing liquids
regularly.
External Walls
• The external walls of the microwave should only be cleaned with a
damp cloth. Please ensure that no water enters the openings in the
housing and therefore inside the appliance.
• Open the microwave door before cleaning the control panel in order
to avoid accidentally switching on the appliance.
Accessories
• Clean the glass plate in warm soapy water or in the dishwasher.
Dry it before reinstalling it in the microwave.
• Regularly clean the guide ring and the inside of the bottom. You
may remove the guide ring and manually clean it. Use a mild deter-
gent or glass cleaner. Dry thoroughly. Make sure to position the ring
properly afterwards.
• Clean the grill after each use with a dishwashing detergent or place
it in a dishwasher for cleaning.
Odours
In order to remove any unpleasant odours that may emanate from
the microwave, place a dish lled with water and lemon juice that is
suitable for microwave use in the oven and heat it for approximately
5 minutes. Then wipe out the oven with a soft cloth.
Oven Light
If you need to replace the lighting in the oven, please contact a spe-
cialist workshop near you.
Troubleshooting
Malfunctions are often just caused due to minor problems. Before contacting our customer service, please check the table below:
Problem Possible Cause Notes / Solution
Radio or TV reception is interrupted
during microwave operation.
The electromagnetic elds of this appliance
might interfere with the pictures and sound
of special frequencies.
This is normal and not a malfunction. Position the appli-
ances further away from each other.
The appliance is not supplied with
electricity.
Faulty mains socket. Try another socket.
Check the house fuse.
The display shows “
”. There was a power failure. Set the clock again.