User guide

DM-14B & DM-14C User’s Guide

PROGRAM STORE MENU (MEMORY)

The MEMORY MENU is very easy to use and is required to store programs. Basically, if you rotate the encoder, you

move the cursor (grey background) to the line that corresponds to the parameter to be adjusted, for example QPSK as

shown below.

Press the encoder and it will position on the value of the parameter/status you want to adjust/store. (See example under the

frequency line). Once the data required has been adjusted, rotate the encoder and press it again to quit. Rotate the encoder

again to go to STORE? or OVERWRITE? (STORE? appears automatically if the program number to be stored in the plan

has not yet been used, alternatively the word OVERWRITE? appears, to allow you to overwrite/replace an existing

program). Press encoder again to store the program. The program number increases one number at a time, e.g. it will go to

2 (only if the programs have never been stored before, if not go ahead one at a time manually). The cursor will go to the

parameter to be adjusted (e.g. frequency for the QPSK function shown below). If you do not need to modify any other

parameters, adjust only the frequency of the next program, for example 2. Press the encoder again to quit and using the

arrow keys go to STORE, press ENTER again to store and continue until you have completed all the channels/programmes

required.

N.B. You can store without navigating on STORE? by pressing MEMORY for 2 seconds.

It is possible to store up to 199 mixed programmes for each plan in each of the various modes of the instrument (e.g.

RADIO-TV-SAT-etc even with different standards, for example France/Europe or China/Hong Kong or Russia/Europe)

To exit the PROGRAM STORE menu, press the MEAS/ESCAPE key and you will always go directly to the main menu

MEASURE. Press MEAS/SPECT again to go to SPECTRUM mode. Easy, don't you think? Remember that it is not

possible to store on identical programmes, because this is not necessary, however if you want to do this, simply move the

frequency by 25 KHz in TV and 100 KHz in SAT.

N.B. If in the MEAS menu, instead of the programme you find two small lines, you must have varied a parameter, enter in

the programme and bring it to the one required (or if you want to keep that configuration press MEMORY to store it).

The VHF channels, e.g. E10-Z10-S10 cannot be selected from the numerical keyboard, but must be selected using the UP

and DOWN keys.

REMEMBER THAT:

• You have 99 memory plans available

• You can store up to 199 mixed programs in each plan (RADIO-AN TV-QPSK-QAM- 8VSB - COFDM-DAB)

• We suggest you store a plan for each city or each type of installation; this will facilitate the registration of measurements

and data of the various installations (Data Logger) and the subsequent PC filing and print-out.

For your commodity you can note the plan and program in the table on pages 108 and 109.

”

to Store