User guide

Clickfree Transformer User Guide Restoring my content
Copyright © 2009 Storage Appliance Corporation. 23
same name in the same location, but only after asking your permission.
If you prefer, you can easily tell Clickfree restore to restore your files to a place on your
computer’s hard drive where they will not replace the files you already have.
For details, see:
“How do I let Clickfree restore decide what to restore and where?” on page 23
“How do I change how Clickfree restores content?” on page 27.
HOW DO I LET CLICKFREE RESTORE DECIDE WHAT TO RESTORE AND WHERE?
You can allow Clickfree to make the decisions about what to restore and to where, but you
need to confirm what Clickfree plans to do.
To let Clickfree decide what to restore and to where:
1. Make sure that your computer is switched on and has finished starting up.
2. Log in, if that is what you normally do.
3. Connect the Clickfree Transformer to your computer by plugging it in to a USB port.
Clickfree starts up just as it did when you used it to back up your content.
4. Wait for the Clickfree window to appear – this may take up to 60 seconds.
5. If your external hard drive came with a power adaptor, plug it in now to the hard drive
and to a power socket.
6. Connect the external hard drive your content is backed up on to the Clickfree
Transformer as shown here:
The Clickfree
Welcome window appears with the countdown, just as it did when you
used it to back up your content.
But this time you are not going to allow Clickfree to start the backup.
Because you have backed-up content on your external hard drive, the countdown
screen now shows buttons at the bottom to allow you to
View Files and Restore files: