User Guide

How to set your own se cret valet code

You may choose any 1-, 2-, 3- or 4-digit code, but the first digit must not be a zero (e.g.,

1023 is a valid code, 0123 would not be a valid code). You can also change your valet

code whenever and wherever you want. See User-selectable features on pages 18-19.

Ex am ple

Let’s say you want to set a valet code of 2301. To do so, you would do the following:

1. From the Table of user-selectable features on page 19, you would note that the Set a

new secret disarming/valet code feature is in column 2, row 7.

2. Enter program mode by turning on the ignition, entering your current valet code,

then pressing and holding the PlainView 2 switch’s ✱ button for 3 seconds until you

hear a chirp.

3. Select column 2 by pressing the unmarked button twice. After a brief pause, you will

hear 2 chirps to confirm that you have selected feature column 2.

4. Within 5 seconds, select row 7 by pressing and releasing the PlainView 2 ✱ button 7

times. To help you count, you will hear a chirp each time you press the ✱ button. After 7

presses, immediately press the unmarked button, then immediately enter your new code.

Example: To enter 4301 as your new code, you would press the switch buttons

in this manner: ✱✱✱✱ un marked, ✱✱✱ un marked, un marked, ✱ un marked.

5. Wait for the 2-chirp confirmation.

6. Turn off the ignition to exit program mode (you’ll hear a 3-chirp confirmation).

7. VERY IMPORTANT: You must immediately test your new secret valet code:

Turn on the ignition, enter your new code, then press and hold the unmarked button

for 3 seconds. The LED will illuminate to indicate that the system is in valet mode (see

page 11 for information on valet mode). Turn the ignition off. The system is now in valet

mode.

If the LED does not illuminate, the new code you programmed and the one

you just entered do not match. In such a case, the system will revert to the

previous code.

8. To exit valet mode and return to normal operation, turn the ignition on. The LED

will turn off to indicate that the system has exited valet mode and is now in normal

operating mode. You may now turn off the ignition.

Re mote con trolled valet mode en try and exit

You can even enable or exit valet mode with your remote control simply by

simultaneously pressing the and ✱ buttons. In addition to the LED indications

noted above, two indicator light flashes will confirm that you have remotely enabled

valet mode, a single flash confirms valet mode exit. If you prefer, you may turn off remote

controlled valet mode as noted in the User-selectable features section on pages 18-19 so

that the system cannot be placed in valet mode via the remote control.

Key less en try in valet mode

Even if the valet mode is enabled, you can still remotely control the system’s

convenience features and accessories. For instance, pressing the button as if you

were disarming will unlock the doors (indicated by one indicator light flash) and turn on

the interior light(s). Press the button again and the doors will lock (confirmed by

two flashes). You may also use the other remote control buttons to activate options such

as a remote boot release or remote engine starting.

REV B UPDATE PAGE: ONLY PAGES 6, 7, 12 and

the back cover change, all other pages same as REV A.