User Guide

User- selectable fea tures

Concept 300 lets you set many of its features to your own preferences. Once you’ve

changed a few settings, you’ll find that programming Concept 300 is so easy you can

even do it whilst driving! The system features are preprogrammed as noted by the bold

type in the Table of user-selectable features on page 19. To change any of the settings, use

the steps noted below. To restore the feature to its factory setting, just repeat the

procedure.

NOTE: For even greater programming ease and even more system control,

consider the CliffNet Wizard option noted above.

Step- by- step pro gram ming in struc tions

1. Refer to the Table of user-selectable features and make note of the column (across)

number and the row (down) number of the feature(s) you wish to program.

2. Turn the ignition on, or start the engine (skip this step if the engine is running).

3. Enter your valet code (see page 11), then press and hold the ✱ button of the

PlainView 2 switch for about 3 seconds until you hear a siren chirp. Release the

button.

4. Select the feature column: Press and release the unmarked button of the PlainView 2

switch the same number of times as the column number. Pause. You will hear the

same number of chirps as the column number you have selected, audibly confirming

your selection.

5. Select the feature row: Press and release the ✱ button the same number of times as the

feature’s row number. You’ll will hear a chirp each time you press.

NOTE: You have 5 sec onds to en ter the row number af ter se lect ing the col umn

number. If you wait too long, the sys tem jumps back to the “Fea ture Se lect”

po si tion (this is in di cated with 3 chirps). If you wait an other 60 sec onds, the

sys tem will exit pro gram mode.

6. Pause. You will hear either one or two chirps: Two chirps = ON, one chirp = OFF

(If there is a NOTE for the selected feature, perform the actions noted).

Some fea tures, such as Chirps (col umn 2, row 1) have mul ti ple set tings.

Re se lect the fea ture ad di tional times to prog ress through each set ting.

7. You may now select another feature or exit program mode:

a.To select another feature in that same column, repeat step 5 within the next 5

seconds (after 5 seconds, 3 chirps mean you are back to the “Feature Select”

position).

b.To select a different feature column, go to step 4.

c.To exit program mode, turn the ignition off (you’ll hear 3 chirps and the LED will

turn off to indicate exit of program mode). If driving, just wait 60 seconds and the

system will automatically exit program mode.

If you make an er ror, just turn off the ig ni tion and start again.