User Guide

Add ing new re mote con trols
For other drivers of the vehicle in your family, you can purchase additional remote
controls from any Clifford Dealer (or ring our UK Customer Service Department on
0800 929949 or 0181 646 8440) and program them into your Concept 300 system
yourself.
Each Concept 300 will respond to as many as four Concept 100, 300, 400, 600 type
remote controls.
NOTE: Your Concept 300 will re spond only to Concept 100, 300, 400 and 600
type ACG 2 re mote con trols. Older Clif ford ACG and non- ACG re mote
con trols are not com pati ble with the Concept 300.
To add a new remote control to the system, use the Add new remote feature (column 1,
row 1) of the User-selectable features on pages 18-19.
You may also assign unused buttons and/or button combinations from the remote
controls of other Concept 100, 300, 400 and 600 systems to your Concept 300 as noted
in column 4 of the User-selectable features on pages 18-19.
How to erase the codes of lost or sto len re mote con trols
If one of your remotes is ever lost or stolen, you can erase it from the memory to make
sure that the missing remote control can never again be used to disarm your system.
To do so, you will use the Clear All Remotes feature noted on the Table of User-Selectable
Features (feature column 2, row 6) on page 19. This Clear All Remotes feature will erase
all remote controls from the Concept 300 memory. Then simply reprogram each
remaining and/or replacement remote control as noted in the Adding new remote controls
section above.
Auto matic re mote con trol low- battery warn ing
If your remote control battery is very low, you will hear an unusually low-pitched chirp
whenever you remotely disarm rather than the chirp that you normally hear. Your
Concept 300 system will continue to sound this low-pitched chirp warning every time
you disarm until you replace the battery.
Since this is a warning indication, you will hear this low-battery warning even if you use
the and ✱ button combination silent disarming feature (see page 6 & 7).
Re mote con trol bat tery re place ment
Replacement of a remote control battery is simple, but any Authorised Clifford Dealer
will be happy to do it for you without cost provided that you buy the replacement battery
at their shop (it’s a good idea to keep a spare of each battery type in your glove box just
in case).
1. Insert a small, thin screwdriver blade in the slot near the keyring opening (you may
leave the keyring in place) and turn it to separate the two halves.
2. Remove the old battery noting the + and – indications and replace it with the new one.
3. Put the enclosure back together by first aligning the top of the remote, then snapping
the case back together at the bottom.
8