User Guide

Two- Point In ter nal AutoIm mo bi li sa tion
Whilst armed, your Concept 300 assures your vehicle is immobilised by automatically
locking out both the ignition and starter. The system’s dual internal immobilisation
circuits ensure that a thief will not be able to start your vehicle’s engine even if he had a
duplicate of your car key. What’s more, even if he were to find the system control unit
and tear it out of your vehicle, he still would be unable to start your car’s engine!
However, unlike AutoArming described on page 10, AutoImmobilisation occurs 30
seconds after you turn off the ignition regardless of whether you open or close any doors.
What’s more, disabling the AutoArming feature has no effect on AutoImmobilisation.
When you remotely disarm your Concept 300 system, the AutoImmobilisation circuits
automatically disengage. You then have 30 seconds to start the engine (or turn the
ignition switch to its “ON” position). If more than 30 seconds pass, the immobiliser will
automatically reactivate. This will be visually indicated by the LED repeatedly flashing,
but at a slower rate than that of the normal rapid “armed” indication flash rate.
To dis arm the Auto Im mo bi liser, use the re mote con trol to arm and then
disarm the system, or turn on the ignition and press button on the remote
control.
Op tional Wire less Fu el Guard Mod ule™
Our ingenious optional Wireless FuelGuard Module makes your vehicle undrivable by
interrupting the fuel delivery system whilst the system is armed, and it can’t be defeated
even by the most sophisticated thief.
Why not? Because this unique Clifford innovation unfailingly provides reliable fuel pump
obstruction without any wires connecting it to the system control unit. That means that
a thief would not be able to find the Wireless FuelGuard Module even if he tried locating
and tracing the system wires, since there are no wires for him to trace! Operation is
completely automatic and user-transparent.
If you have had the optional Wireless FuelGuard Module installed, make
sure to keep the rec ord your Clif ford in staller pro vides as to the Wireless
FuelGuard Module lo ca tion in case your ve hi cle needs fu ture serv ic ing.
En gine Re start Fea ture
Thirty seconds after shutting down the engine, the Two- Point AutoImmobilisation
electronics (and the Wireless FuelGuard Module, if you have this option) will engage,
preventing engine starting. To restart the engine, simply do the following:
1. Turn your ignition switch to the “ON” position.
2. Press button on the remote control. This will disengage the immobilisation.
3. You may now start the engine.
Smart boot re lease op tion
If the optional remote boot release feature was installed, you may use the button on
the remote control to release the boot latch. Your system has a built-in electronic interlock to
prevent unintentional activation of the remote boot release when you drive, or when the
system is armed. This interlock requires installer programming, so if you have remote
boot release, you may want to verify that it will NOT activate whilst the system is armed.
9