Automobile Alarm User Manual

Configurations

Placing the system into the remote pair mode

1. Open one or more of the vehicle doors.

2. Turn the ignition to the On position.

3. Press, release, then press and hold the Control button (on Con-

trol Center).

4. The control center LED begins to ﬂash and the siren emits one

chirp to conﬁrm the system is in Pair mode, the Control button

can be released. The system will stay in Pair mode for 60

seconds or until the doors are closed or ignition turned off.

The siren will emit one short and one long chirp when it exits

remote pair mode.

1. Toggle to

Remote Pair

and press the menu wheel, the Remote

Pair screen with on-screen instructions is displayed.

2. Press and hold the

button. The remote’s LED ﬂashes, then

the siren chirps, and remote tones play to conﬁrm pairing. The

PAIRING SUCCESSFUL

screen is displayed before returning to the

Adjustments feature menu screen.

3. If the remote does not learn the system ID it displays the

PAIRING FAILED

screen after the button is released before re-

turning to the Remote Pair screen. Press and hold the

button to try again. If the siren chirps but remote tones are not

played, Press and hold the

button to try again until the

tones are played. If the siren does not chirp shortly after the

remote LED begins ﬂashing make sure the system is in remote

pair mode.

Sensor Adjust

Your Responder HD security with remote start system has a built in

shock sensor used to detect intrusion attempts on your vehicle. The

sensor sensitivity can be adjusted to optimize your vehicle’s detection