Installation guide

© 2006 directed electronics
11
been restored to the module.
NNOOTTEE::
In order for the system to bypass the immobilizer with the jumper in place, the
unit must have ground on the 18-pin harness.
door lock harness wire connection guide
___
___
___
IIMMPPOORRTTAANNTT!!
The door lock outputs are low current and should not be attached direct-
ly to any high-current device; they are only to be used to activate relays
BLUE (-) Unlock, (+) Lock Output
EMPTY (+) 12V Protected, Low Current for 451M
GREEN (-) Lock, (+) Unlock Output
H3/1
H3/2
H3/3