Installation guide

blue and orange wires, zone 3 zone 8

These wires are multiplex inputs. If a (-) input of less than 0.8 seconds is supplied to

either wire, the Warning Zone response will occur. A (-) input of longer than 0.8 sec-

onds to either wire will initiate the triggered sequence and report Zone 3 or Zone 8.

NOTE: For mounting and adjustment of sensors, please refer to the

Mux Sensors

sec-

tion of this guide.

mounting the receiver/antenna

NNOOTTEE::

Be sure not to bundle excess cable as this will reduce the range.

The receiver/antenna position should be discussed with the vehicle owner prior to

installation since the antenna may be visible to the vehicle’s operator.

The best position to locate the receiver/antenna is centered high on either the front or

rear windshield. For optimal range, the antenna should be mounted vertically. It can

be mounted horizontally in relation to the windshield or under the dashboard away

from metal, but range will be reduced. Metallic window tint can also affect range, so

this should be a consideration when determining the mounting location.

After determining the best mounting location, follow these steps:

1. Clean the mounting area with a quality glass cleaner or alcohol to remove any

dirt or residue.

2. Plug the receiver/antenna cable into the receiver/antenna.

3. Mount the receiver/antenna with double-sided tape.

4. Route the receiver/antenna cable down the window pillar to the control module

AUDIO

MICROPHONE

BLUE (ZONE 3)

RED

BLUE (ZONE 8)

BLUE

RED

506T AUDIO SENSOR

BLUE

SHOCK SENSOR PORT

ORANGE

504C SHOCK SENSOR