Installation guide

and plug the cable into the control module.

arming/disarming diagnostics

The systems microprocessor monitors and reports all active and violated zones when

arming and disarming the system.

arming

Zones that are triggered at the time the system is armed are reported by an addition-

al set of status chirps called Malfunction AutoBypass. The specific zone bypassed is

then reported by the LED. For more zone information, refer to

Table of Zones

section

of this guide.

disarming

If a zone is triggered, three disarm chirps will sound. The specific zone that was trig-

gered is then reported by the LED when the ignition is turned on. For more zone infor-

mation, refer to the

Table of Zones

section of this guide.