Installation guide

© 2006 directed electronics
25
Be sure to document changes by taking note of all feature changes made in program-
ming mode.
To enter the User Selectable Features programming:
1. Ignition on - Turn the ignition to the run position or start the engine.
2. Enter PIN - Enter the factory preset PIN code of 2 by pressing on the
PlainView 2 Valet switch twice, then once.
NNOOTTEE::
If the factory preset PIN has been changed, the new PIN must be entered.
3. Hold/Chirp/Release - After entering the PIN code, press and hold until a
chirp is heard and the LED turns on, then release the button. You have now
entered the feature selection position of the User Selectable Features grid.
4. Column select - Press the same number of times as the desired column. After
a pause the siren will chirp the same number of times as the selected column for
confirmation.
5. Feature select - Press the same number of times as the desired feature. The
siren will chirp with each press. The feature can now be changed using the
remote control.
6. Feature change - Press the arm/disarm button on the transmitter. If the system
chirps once, the feature has just turned off; if the system chirps twice, the feature
has just turned on. If the feature has more than two settings, continue pressing
the arm/disarm button on the transmitter to toggle through the settings.
To advance to the next feature in the same column, press the same number
of times as the desired feature within 60 seconds; to change a feature in a
different column begin at step 4 by entering the column number first and then
the row number.
NNOOTTEE::
Refer to the Feature Descriptions sections of this guide for important notes and
descriptions of the system features and programming.
7. Exit programming - To exit programming mode turn the ignition off or wait 60
seconds without pressing the PlainView 2 Valet switch. The siren will chirp three
times to indicate programming mode has been exited.