Installation guide

© 2006 directed electronics
28
within a one hour period.
remote valet - off/on
z
Off: The alarm can not be put into valet mode with the remote control.
z
On: The alarm can be put into valet mode with the remote control.
entry delay - off/on
z
Off: There is no entry delay when the system has passively armed. The system
will trigger instantly when a door is opened.
z
On: If the system has passively armed, it will not trigger for 15 seconds after a
door is opened allowing the user to enter the vehicle and disarm the system via
the PlainView 2 Valet switch.
reset to default settings
z
All system settings (except PIN and remote programming) in the User
Programming grid will be reset to their default factory setting as indicated in
bold lettering.
z
Press the arm/disarm button of the TX; the siren will chirp twice as confirmation.
panic off/on
z
Off: The panic feature is not available.
z
On: The panic feature is available.
auto start setting - off/battery only/temp only/battery and temp
z
Off: The vehicle will not autostart.
z
This feature is only available with the IntelliStart option.
z
Battery: The vehicle will only autostart when the car battery gets low.
z
Temperature: The vehicle will only autostart at a preset low temperature.
z
Battery and temperature: The vehicle will autostart with a low car battery or low
temperature.
NNOOTTEE::
Temperature and battery calibration and settings can be made only with the
Cliffnet Wizard.
user selectable features descriptions - column three
The features in this column pertain to programming individual transmitter channels in
custom configurations. Following is an explanation of the features. Program the indi-
vidual transmitter channels following the instructions in programming note #2.
arm/disarm only